Just a very quick post with some images of an industrial safe combination lock.
Here the tumblers are lined up to allow the lock to open.
The locking bar has dropped into the slots in the tumbler plates & engaged with the cam.
Rotating the cam pulls the bolt into the lock, allowing the door to open.
The dial screws into the cam plate to allow the mechanism to be operated.
Connection
The parts arrived for my adjustable laser diode driver! Components here are an LM317K with heatsink, 100Ω 10-turn precision potentiometer, 15-turn counting dial & a 7-pin matching plug & socket.
Here is the schematic for the driver circuit. I have used a 7-pin socket for provisions for active cooling of bigger laser diodes. R1 sets the maximum current to the laser diode, while R2 is the power adjustment. This is all fed from the main 12v Ni-Cd pack built into the PSU. The LM317 is set up as a constant current source in this circuit.
Here the power adjust dial & the laser head connector have been installed in the front panel. Power is switched to the driver with the toggle switch to the right of the connector.
The LM317 installed on the rear panel of the PSU with it’s heatsink.
Connections to the regulator, the output is fully isolated from the heatsink & rear panel.
