Intel – Experimental Engineering

Posted on February 20, 2011February 10, 2011 by The Engineer — Leave a comment

Garmin eTrex

Pocket sized GPS navigator. Here is shown the greyscale dot matrix LCD.

Serial interface on the back of the unit. Pinout from left is +3v, Rx, Tx, GND.

PCB Removed from the casing. RTC backup battery in the centre of board, CPU & flash ROM on the left. GPS chipset is under the shield on the right.

Front of the PCB, GPS antenna on the right, LCD panel left.

LCD folded back from the PCB. Driver IC can be seen attached to the ribbon.

LCD Panel backlight. Requires 200v AC at 20kHz to glow green.

GPS chipset with the shield removed.

Posted on August 26, 2010 by The Engineer — Leave a comment

Motorola V360v

Here is a more modern phone, the Motorola V360v. Features include Dual screens, 640×480 VGA camera, full col

our TFT Main LCD, SD-Micro slot.
Here on the back the grey scale LCD can be seen, with the camera lens to the right of the Motorola logo

Here the phone is opened showing the keypad & the full colour TFT LCD display.

Here the battery is removed from the unit, showing the SIM connector. The antenna cover is still on at the bottom.

The antenna cover has been removed in this shot, the antenna is the white section at the bottom, With the loudspeaker & the external antenna connector hidden at the right.

Here is the main PCB. Parts from left are the Bluetooth module at the top, supplied by Broadcom, the SD Card socket at the bottom. Main CPU next to that is the Freescale SC29343VKP. Above right of the CPU is the Freescale SC13890P23A Charger, Power & Audio IC. Below is the SIM card socket. Under the main CPU is the Intel Flash memory IC. ICs inside the shields are the RF sections for transmit & receive.

Rear of the display unit showing the monochrome LCD. The camera module on the bottom left. Ear speaker on the far right of the unit.

Main colour TFT LCD.

Camera module removed from the LCD unit.

The vibration motor attached to one of the LCD looms.

Posted on August 25, 2010 by The Engineer — Leave a comment

Ericsson GA628

Here is a phone from the mid 90s, the Ericsson GA628. Here visible is the front of the unit with keypad, & single line monochrome LCD for number display.

Here the battery is removed from the phone, showing the SIM card socket. At the top under the antenna stub is the socket for an external antenna.

Here the front is removed from the phone, PCB on left, rear of keypad on right. Microphone is at bottom of keypad, with speaker at the top. Top right of the PCB is the ringer buzzer, left is shield for RF amplifier.

Here is the back of the main PCB, RF sections on left & centre. Processing & memory on right.

This phone had a Ni-Mh battery, before Li-Ion batteries were introduced.

The LCD from the front of the phone is shown here. A simple dot matrix single line unit.