Li-poly – Experimental Engineering

This is just a few notes on the repair of an eCig battery (1Ah Tornado).

These batteries seem to have a flaw in which they will randomly stop working, while still displaying all the normal activity of the battery.
Here is what I have found.

Here the battery has been partially disassembled, with the control circuitry exposed here at the end of the unit. All the wiring here is fine & the electronics themselves are also OK, due to the LEDs still operating as normal when the button is pushed. The 1000mAh Li-Poly cell is to the right.

Here the end cap has been removed from the opposite end of the battery & the problem is found: the short wire here is the GND return for the atomiser, normally connected to the negative terminal of the battery in the tube, however here it has broken off.
This is most likely due to either the cell moving inside the tube during normal operation, weakening the solder joint, or simply a bad solder job from the factory. (This lead-free ROHS bullshit is to blame).

Here the wire has been successfully soldered back on to the battery tab. I have also added a small dab of hot glue to hold the battery in place on the inside of the tube, & replaced the solder on the joints with real 60/40 leaded solder. £15 saved.

Here is a PSP Slim that recently died.

For those that are interested, here is the ID label, this is a PSP-2003.

Here the front of the unit has been removed, showing the first internal components.

Here is the unit with the LCD removed, here the mainboard is partially visible.

Left pad unit removed from the PSP, with the left speaker & the memory stick slot cover.

Rear of the left pad assembly, showing the speaker.

Joypad removed from the casing. Resistive unit.

Headphone/data board removed from the casing. This also has TV-Out on the PSP-200x series.

Mainboard removed. Main CPU is at the top. Sockets around the bottom connect to the UMD drive & UMD Drive.

Closeup of the main chipset. CPU is the top IC.

Rear of the mainboard, Memory Stick socket on the right.

Closeup of the WiFi chipset & the charging power socket on the right.

Closeup of the bettery connector & the charge controller IC.

UMD Drive removed from the rear of the casing. This is a miniature DVD style drive, using a 635nm visible red laser.

Rear of the UMD drive, showing the laser sled & drive motors. Both the spindle motor & the sled motor are 3-phase brushless type. The laser diode/photodiode array is at the top of the laser sled.

Tag: Li-poly

Tornado eCig Battery Repair

PSP Slim